Gamo LLCP Laser and Light with Scope Mount - Manual (Page 4)

Align (rotate) the vertical and horizontal axes of the laser sight for the proper alignment of the
windage and elevation of the laser dot. Tighten the screws in the upper and lower half of the
mount. Tighten all the mount screws using a non permanent thread lock.
B.) REPLACING THE FLASHLIGHT BATTERIES DANGER !
WARNING !
CAUTION !
BE CERTAIN THAT YOUR AIR GUN IS UNLOADED AND POINTING IN A SAFE
DIRECTION
Remove the light bulb assembly (located in the front end of the flashlight) by turning the cap
counter-clockwise. Place the 3V battery (CR123A) inside, with the positive end facing out.
Replace the light bulb assembly securely by turning it clockwise until tight. The flashlight is
now ready for use.
C.) REPLACING THE LASER BATTERIES
Remove push button or remote switch housing (located at the rear of the laser) by turning the
cap. Insert (3) LR44 batteries. Replace the push button or remote switch housing and tighten.
The laser is now ready for use.
D.) REPLACING THE LASER OR FLASHLIGHT SWITCHES
Remove the push button assembly from the back of the flashlight by rotating it counterclockwise
until loose. Install the new switch by rotating it clockwise until tight and secure.
DANGER !
WARNING !
CAUTION !
DO NOT LOOK DIRECTLY INTO THE LASER BEAM OUTPUT APERTURE
DURING OPERATION. PERMANENT EYE DAMAGE MAY RESULT. DANGER !
WARNING !
CAUTION !
EXERCISE SAFE AIR GUN HANDLING. SHOOT ONLY AT AN APPROVED GUN
RANGE OR SUITABLE LOCATION. USE EYE AND EAR PROTECTION AS NECESSARY.
4
4. Place upper half of mount onto laser sight and flashlight, DO NOT TIGHTEN SCREWS
YET. Before tightening the screws in the upper half of the rings, adjust the laser sight and
flashlight back or forward for the best position to allow removal of the push button switches
or installation of the momentary ON/OFF switches.