Gamo LLCP Laser and Light with Scope Mount - Manual (Page 5)

4
E.) POSITIONING THE REMOTE SWITCHES
1. Once you have decided the location of the switches on the rifle stock, place adhesive side
of velcro strip on the stock of the rifle by pressing the adhesive portion against the stock.
2. Attach the other adhesive portion to the back of the pressure sensitive switches by
pressing the adhesive side of the surface of the Velcro strip against them.
3. Secure the pressure sensitive switches to the stock by pressing both parts of the
Velcro together.
F.) ZEROING THE LASER SIGHT
First, the laser needs to be aligned with the path of the pellet/bullet to do this follow the steps
described below.
1) Activate the laser by pressing the switch.
2) From a bench rest position, fire three shots at the
center of the target.
3) Observe were the pellets or bullets strike the
target. Keeping the laser dot pointing at the
center of the target and using the windage and
elevation adjustments screws located in the laser
body, move the laser dot to the center of the
group formed by the three shots previously fired.
Fire three more shots and note the points of
impact on the target. Make additional adjustment
of the laser as necessary.
G.) ADJUSTING THE LASER WINDAGE AND ELEVATION.
1) The elevation adjustment screw is located on top of the laser. When the screw is turned
counterclockwise, the Laser dot will move “Up” and when is turned clockwise the laser dot
will move “Down”.
2) The windage adjustment screw is located at 45° angle on the right side of the laser body.
When turned counter-clockwise, the laser dot will move to the “Right”. When turned clockwise
the laser dot will move to the “Left”.
3) To align the laser dot with the center of the cross-hairs of the reticle, move it by turning the
windage and elevation screws on the laser.
5