Drive & host adapter install, Page 16 – Granite Digital SATA 8 Bay Rack Expandable User Manual
Page 16
Granite Digital • 3101 Whipple Rd. • Union City, Ca. 94587
www.granitedigital.com
Granite Digital • 3101 Whipple Rd. • Union City, Ca. 94587
www.granitedigital.com
Drive & Host Adapter Install
Page 16
The rear panel of the 2- 4 Bay SATA System is simple and easy to use.
The IEC (standard computer type) power cord plugs into the built in 250 watt
Micro ATX power supply. Next to that connector is the power on switch. This
switch can be used to power the drive mechansims on or off... or leave this
switch in the on position and simply pull the drive mechanisms out about 1”
and the drives will disconnect and power down.
SATA “L” connectors
from shielded cables
plug in here.
IEC Power Cord Plugs in
Micro ATX Power Supply.
The SATA “L” type connectors are connected directly to the tray in front
of them. Marking them 1 - 4 or 1 - 8 to match the controller cards channels
will make it easier to find a drive that reports an error and can be done with a
marking pen on label maker.
When inserting the SATA Data Cable make sure the orientation is correct.
The “L” type SATA connector only plugs in one way.
Power ON Switch
Voltage Selector Switch
4 - 8 Bay
Rack Rear