Granite Digital SATA LCD Hot-Swap - Manual (Page 14)

Granite Digital • 3101 Whipple Rd. • Union City, Ca. 94587 www.granitedigital.com
DRIVE INSTALLATION Page 14
Setting the Temperature Alarm
The Mode and Set Buttons are used to adjust the alarm. Push the Mode
Button for 2 seconds to enter the set mode. There are a total of 4 settings that
can be changed. The first is T1 (Temperature 1), then F1 (Fan 1), T2
(Temperature 2), and F2 (Fan 2). Pressing the Mode Button allows you to
select any of the 4 settings. When the desired mode has been picked, use the
Set Button to adjust its value. To exit the Set Mode simply hold the Mode
Button down for 2 seconds and it will return to the operation mode.
Reset the
LCD display
Switch
between
C and F
Mode Button
...hold down
2 seconds
Set Button
...adjusts
mode settings
Drive
Inserted LED Power
On LED
Temperature
readout FAN speed
readout
Once the alarm settings have been established the alarm will monitor
both the temperature and the fan speed. Should either go above its threshold a
buzzer and flashing display will alert the user to the problem. This buzzer
automatically stops after 30 seconds but the display will continue to flash.