Iris Sample Processing StatSpin® CritSpin Microhematocrit System - Manual (Page 5)

1
Section
1
Unpacking and Installation
Inspect Packaging
The CritSpin and its accessories are delivered in one carton. If the centrifuge or accessories have suffered
any damage in transport, please inform your carrier immediately.
NOTE: Save shipping carton and components to simplify return should service be required.
Verify Contents
The CS12 & CS22 package contains:
One CritSpin Centrifuge (Model No. M961)
One Hematocrit Rotor (Product No. RH12)
One Universal Switching Power Supply
(StatSpin Product No. 01-3553-001, APS Product No.
AD-740U-1240)
One grounded line cord (for North American use only)
One Operator’s Manual
One Sample Pack containing various consumable products
The CS22 package also contains:
One CSD1 Digital Reader with power cable connector (refer to CSD1 operator’s manual)
Install System
1. Place the CritSpin on a level surface suitable for laboratory instrumentation.
2. Maintain a 300mm clearance boundary around the centrifuge for ventilation and safety.
3. Position the CritSpin away from direct sunlight and sources of heat or cold.
(See Appendix A for specifications.)
Connect Power
Plug the power supply into a grounded outlet supplying the voltage and frequency indicated on the
power supply. When power is connected, the Power On LED will illuminate and the cover lock will
release.
WARNING - North American Installation: Only use the power supply included with the unit.
Use of other power supplies or transformers will damage the CritSpin electronics and void the
warranty.
WARNING - Outside of North America: Do Not Use the Line Cord Supplied. Use power cord
for at least 1.0 Amp or more with an IEC320/CEE22 female connector and male connector
suitable for the power outlet to be used.
Note: Please refer to the CSD1 Digital Reader Operator’s Manual for installation
instructions.