Kraus KGU-434B User Manual

Page 4

Advertising
background image

apply a bead of caulk (not included) to the underside of the sink flange. For final

fit, make sure each sink clip is pulled back as illustrated. Position the sink into the

countertop opening.

secure the sink by pivoting the sink clips into the position illustrated and tighten screws

in the front, then tighten Rear and side screws.

Caulk

Step 5

Step 6

TOOLS REQUIRED:

• tape Measure

• Retractable utility Knife (x-acto type)

• Masking tape

• Caulk

• Rubber Mallet

• Drill

• safety Glasses

• Phillips Head screwdriver

• 11/4” Hole saw

• saber saw (if counter top cutout is required)

IMpORTANT INSTALLER NOTE: READ ALL INSTRUCTIONS CAREFULLY

BEFORE STARTING

If you purchased the Dual Mount Granite sink there are two “Master templates” packaged
with the sink that you are installing. Before proceeding any further You Must identify
the template pattern that is required in order to install the sink either as a toP Mount
installed on the top of the counter or as an unDERMount installed to the underside of
the counter.

a.) TOp MOUNT INSTALLATION:

select the template pattern from the Master top Mount template that corresponds to
the model number of the sink that you are installing, the model numbers as shown in the
line break of the template in the bottom center position of the Master template. using a
Retractable utility Knife, cut carefully along the line of the template that corresponds to
your sink model until you have created the cut out area on the Master template, keep the
cut out area to follow instructions.

b.) UNDER MOUNT INSTALLATION:

select the template pattern that from the Master under Mount template that corresponds
to the model number of the sink that you are installing, the model number is shown in
the line break of the template in the bottom center position of the Master template. using
a Retractable utility Knife, cut carefully along the line of the template that corresponds to
your sink model until you have created the cut out area on the Master template, keep the
cut out area to follow instructions.

Advertising
This manual is related to the following products: