Uconnect™ voice command, Voice command for text messaging, Changing the volume – Dodge 2011 Nitro - User Guide User Manual

Page 40: Electronics, Warning

Advertising
background image

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable

level while the Uconnect™ system is speaking. Please note the volume setting for
Uconnect™ is different than the audio system.

NOTE: To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say
“tutorial”. Press any hard-key/button or touch the display (Touch-Screen radio) to
cancel the tutorial.

WARNING!

• Any voice commanded system should be used only in safe driving conditions

following local laws and phone use. All attention should be kept on the
roadway ahead. Failure to do so may result in a collision causing you and
others to be severely injured or killed.

• In an emergency, to use Uconnect™ Phone, your mobile phone must be:

• turned on,
• paired to Uconnect™ Phone,
• and have network coverage.

Uconnect™ VOICE COMMAND

• The Uconnect™ Voice Command system allows you to control your AM, FM radio,

satellite radio, disc player, Uconnect™ Phone, a memo recorder, and supported
portable media devices.

• When you press the Voice Command button

located on the radio faceplate

or steering wheel, you will hear a beep. The beep is your signal to give a command.
If you do not say a command within a few seconds, the system will present you
with a list of options. If you ever wish to interrupt the system while it lists options,
press the Voice Command button

, listen for the BEEP, and say your

command.

Voice Command for Text Messaging

• If equipped with Uconnect™ Voice Command, your Media Center 430N radio may

be able to play incoming SMS messages through the vehicle sound system.

• It also allows you to respond by selecting from various pre-defined phrases.

• Not all phones are compatible with this feature. Refer to the phone compatibility

list at www.dodge.com/uconnect. Connected mobile phones must be
bluetooth-compatible, and paired with your radio.

Changing The Volume

• Start a dialogue by pressing the Voice Command button

, then say a

command (for example, “tutorial”).

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable

level while the Voice Command system is speaking. The volume setting for Voice
Command is different than the audio system.

ELECTRONICS

38

Advertising