Airbag warning light, Serv (service) 4wd indicator light, Transmission temperature warning light – Dodge 2011 Nitro - User Guide User Manual

Page 54: Fuel cap/loose gas cap message, Oil change indicator, If your engine overheats, What to do in emergencies

Advertising
background image

• If a problem is detected, the light will come on while the engine is running. Cycle

the ignition when the vehicle has completely stopped and the shift lever is placed
in the PARK position; the light should turn off.

• If the light remains lit with the engine running, your vehicle will usually be

drivable; however, see an authorized service center immediately. If the light is
flashing when the engine is running, immediate service is required and you may
experience reduced performance, an elevated/rough idle or engine stall and your
vehicle may require towing.

- Airbag Warning Light

• If the light is not on during starting, stays on, or turns on while driving, have the

vehicle serviced by an authorized service center immediately.

- SERV (Service) 4WD Indicator Light

• If the light stays on or comes on during driving, it means that the 4WD system is

not functioning properly and that service is required. We recommend you drive to
the nearest service center and have the vehicle serviced immediately.

- Transmission Temperature Warning Light

• This light indicates that there is excessive transmission fluid temperature that

might occur with severe usage such as trailer towing. If this light turns on, stop the
vehicle and run the engine at idle, with the transmission in NEUTRAL, until the
light turns off. Once the light turns off, you may continue to drive normally.

Fuel Cap/Loose Gas Cap Message

• If a “gas cap” message (shown as gASCAP) appears, tighten the gas cap until a

“clicking” sound is heard.

• Press the odometer reset button to turn the message off.

• If the message continues to appear for more than three days after tightening the

gas cap, see your authorized service center.

Oil Change Indicator

Message

• If an “oil change” message (shown as CHAngE OIL) appears and a single chime

sounds, it is time for your next required oil change.

Resetting The Light After Servicing

• Turn the ignition switch to the ON/RUN position (do not start engine).

• Fully depress the accelerator pedal three times within 10 seconds.

• Turn the ignition switch to the OFF/LOCK position.

IF YOUR ENGINE OVERHEATS

• In any of the following situations, you can reduce the potential for overheating by

taking the appropriate action.

• On the highways — slow down.

• In city traffic — while stopped, shift transmission into NEUTRAL, but do not

increase engine idle speed.

WHAT TO DO IN EMERGENCIES

52

Advertising