Flash to pass, High beam operation, Fog lights – Dodge 2012 Caliber - User Guide User Manual

Page 20: Turn signals/lane change assist, Wiper/washer lever, Front wipers, Operating your vehicle

Advertising
background image

• Rotate the center portion of the lever up to increase the brightness of the

instrument panel lights when the parking lights or headlights are on.

• Rotate the center portion of the lever upward to the next detent position to

brighten the odometer and radio controls when the parking lights or headlights are
on.

• Rotate the center portion of the lever upward to the last detent to turn on the

interior lighting.

Flash To Pass

• Pull the lever toward you to activate the high beams. The high beams will remain

on until the lever is released.

High Beam Operation

• Push the lever forward to activate the high beams.

NOTE: For safe driving, turn off the high beams when oncoming traffic is present to
prevent headlight glare and as a courtesy to other motorists.

Fog Lights

• Turn on the parking lights or low beam headlights and pull out the end of the lever.

Turn Signals/Lane Change Assist

• Tap the lever up or down once and the turn signal (right or left) will flash three

times and automatically turn off.

WIPER/WASHER LEVER

Front Wipers

Intermittent, Low And High Operation

• Rotate the end of the lever to the first detent position for one of five intermittent

settings, the second detent for low wiper operation and the third detent for high
wiper operation.

OPERATING YOUR VEHICLE

18

Advertising