Road tire installation, What to do in emergencies – Dodge 2012 Caliber - User Guide User Manual

Page 68

Advertising
background image

8. Remove the wheel blocks and lower the jack until it is free. Reassemble the lug

wrench to the jack assembly and stow it in the spare tire area. Secure the
assembly using the means provided.

9. Place the deflated (flat) tire in the cargo area, have the tire repaired or replaced as

soon as possible.

10. Check the spare tire pressure as soon as possible. Correct the tire pressure as

required.

Road Tire Installation

Vehicles Equipped With Wheel Covers

1. Mount the road tire on the axle.

2. To ease the installation process for steel wheels with wheel covers, install two lug

nuts on the mounting studs which are on each side of the valve stem. Install the
lug nuts with the cone shaped end of the nut toward the wheel. Lightly tighten
the lug nuts.

3. Align the valve notch in the wheel

cover with the valve stem on the
wheel. Install the cover by hand,
snapping the cover over the two lug
nuts. Do not use a hammer or
excessive force to install the cover.

4. Install the remaining lug nuts with the

cone shaped end of the nut toward
the wheel. Lightly tighten the lug
nuts.

5. Lower the vehicle to the ground by

turning the jack handle
counterclockwise.

6. Finish tightening the lug nuts. Push down on the wrench while at the end of the

handle for increased leverage. Tighten the lug nuts in a star pattern until each nut
has been tightened twice. The correct tightness of each lug nut is 100 ft/lbs
(135 N·m). If in doubt about the correct tightness, have them checked with a
torque wrench by your authorized dealer or service station.

7. After 25 miles (40 km) check the lug nut torque with a torque wrench to ensure

that all lug nuts are properly seated against the wheel.

Vehicles Without Wheel Covers

1. Mount the road tire on the axle.

2. Install the remaining lug nuts with the cone shaped end of the nut toward the

wheel. Lightly tighten the lug nuts.

3. Lower the vehicle to the ground by turning the jack handle counterclockwise.

1 — Valve Stem

4 — Wheel Cover

2 — Valve Notch

5 — Mounting
Stud

3 — Wheel Lug
Nut

WHAT TO DO IN EMERGENCIES

66

Advertising