Reprogramming a single homelink® button – Dodge 2013 Challenger - Owner Manual User Manual

Page 189

Advertising
background image

attached to the garage door opener/device motor.

Firmly press and release the “LEARN” or “TRAIN-

ING” button. On some garage door openers/devices

there may be a light that blinks when the garage door

opener/device is in the LEARN/TRAIN mode.

NOTE:

You have 30 seconds in which to initiate the next

step after the LEARN button has been pressed.
6. Return to the vehicle and press the programmed

HomeLink® button twice (holding the button for two

seconds each time). The EVIC will display “CHAN-

NEL # TRANSMIT”. If the garage door opener/device

activates, programming is complete.

NOTE:

If the garage door opener/device does not acti-

vate, press the button a third time (for two seconds) to

complete the training.

To program the remaining two HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.
Reprogramming A Single HomeLink® Button
To reprogram a channel that has been previously trained,

follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink® button until

the EVIC displays “CHANNEL # TRAINING” Do not

release the button.

3. Without releasing the button proceed with “Program-

ming A Rolling Code” Step 2 and follow all remaining

steps.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 187

Advertising