Sealing a tire with tirefit, A) whenever you stop to use tirefit, B) setting up to use tirefit – Dodge 2014 Charger-SRT - Owner Manual User Manual

Page 498

Advertising
background image

WARNING! (Continued)

TIREFIT Sealant solution contains latex. In case of an

allergic reaction or rash, consult a physician immedi-
ately. Keep TIREFIT out of reach of children. If
swallowed, rinse mouth immediately with plenty of
water and drink plenty of water. Do not induce
vomiting! Consult a physician immediately.

Sealing A Tire With TIREFIT

(A) Whenever You Stop To Use TIREFIT:

1. Pull over to a safe location and turn on the vehicle’s

Hazard Warning flashers.

2. Verify that the valve stem (on the wheel with the

deflated tire) is in a position that is near to the ground.
This will allow the TIREFIT Hoses (6) and (7) to reach
the valve stem and keep the TIREFIT kit flat on the
ground. This will provide the best positioning of the

kit when injecting the sealant into the deflated tire and
running the air pump. Move the vehicle as necessary
to place the valve stem in this position before proceed-
ing.

3. Place the transmission in PARK (auto transmission) or

in Gear (manual transmission) and turn Off the igni-
tion.

4. Set the parking brake.

(B) Setting Up To Use TIREFIT:

1. Push in the Mode Select Knob (5) and turn to the

Sealant Mode position.

2. Uncoil the Sealant Hose (6) and then remove the cap

from the fitting at the end of the hose.

3. Place the TIREFIT kit flat on the ground next to the

deflated tire.

496

WHAT TO DO IN EMERGENCIES

Advertising