Coleman 8350 Series - Manual (Page 19)

19
Lighting the Rotisserie Burner
1. Push and turn on the control knob for the ROTISSERIE BURNER counterclockwise to the
“HIGH” position (Fig. 17 and 22). Wait 5 seconds.
2. Press and hold the electronic igniter button (Fig. 23). You will hear a snapping sound.
3. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes for
the gas to clear before trying again.
4. Repeat steps 1 through 3.
5. Once lit, turn the control knob to the desired setting.
6. If the burner does not light, turn off knob and try match-lighting the burner.
1. Strike and place the burning match (or butane lighter with extension) near the
ROTISSERIE BURNER (Fig. 24).
2. Turn on the ROTISSERIE BURNER CONTROL KNOB while holding a match near
the burner.
Match Lighting - Rotisserie Burner
CAUTION
Use a LONG wooden match, match extension, or butane lighter with extension.
CAUTION
NOTE: Do Not operate the main burners and the Rotisserie Burner at the same time. This
can cause warping of the grill hood.
Fig. 23
Fig. 22
Fig. 24
CAUTION
DO NOT touch hot grill parts with your bare hands!
You MUST use protective gloves.
CAUTION
Be certain the gas is shut off at the L.P. cylinder valve anytime
the grill is not in use.
1. Turn all burner control knobs to off.
2. After the burner flame goes out, turn off the fuel supply. For an
L.P. cylinder, turn the L.P. cylinder knob in a clockwise direction
until it stops.
Shutting Off the Grill