CatEye CC-HB100 - Manual (Page 8)

E
8
2. Mounting to Bicycle
• Attach the magnet on the right spokes of the front wheel.
The spokes must run correctly through the inside of the
magnet as in Fig. 7.
• Attach the sensor with sensor bands A/B to the right fork.
Choose a band that fits the fork diameter (S size for up to
24ø, L for oversize).
1. Insert the band B into the slit of band A, and put the rub-
ber pad inside of the band A (Fig. 8). Adjust the length in
order that the screw-fastening part of the bands are par-
allel when mounted to the fork (Fig. 9).
*To pull out the band B from band A, tug strongly.
2. Mount the adjusted bands to the fork along with the sen-
sor, by temporarily tightening the screw (Fig. 10).
3. Align the magnet's center and the sensor's marking line
(Fig. 11), and make sure of 2mm clearance between the
magnet and sensor (Fig. 12). Then tighten the screw se-
curely. Cut off the excess of sensor band B.
• Secure the wire with tape as in Fig. 13. Wind the wire round
the outer cable upto the handlebar. When adjusting the
length, be careful that the wire will not hinder handlebar
operation.
• By using the rubber pad, attach the bracket close to the
handlebar stem (Fig. 14).
Fig.7
Magnet
Sensor Band A
Sensor Band B
Spoke
Parallel
Wire
Fig.11
About
2 mm
Magnet
Sensor
Sensor
Fig.12 Fig.10
Fig.8 Fig.9
Fig.14
Bracket
Rubber Pad
Rubber Pad
Marking Line
of Sensor
S e n s o r
Band B Front Fork
C e n t e r o f
the Magnet
Wire Securing
Tape
Fig.13