Canon ds6041 - Manual (Page 39)

39
Y Fully Automatic Shooting
Shoot.
•
Compose the shot and press the
shutter button fully.
s The captured image will be displayed
for about 2 sec. on the LCD monitor
( MENU ).
5
•
When focus is achieved, the autofocus and auto exposure setting will
also be locked.
•
If the focus confirmation light <n> blinks, the picture cannot be taken.
(p.64)
•
Out of the seven AF points, the one covering the closest subject is
selected automatically to achieve focus.
•
The dot in multiple AF points may flash in red. This indicates that focus
has been achieved by all those AF points.
•
In the Basic Zone modes (except <I>, <P> and <S> ), the built-in
flash will pop up and fire automatically in low-light or backlit conditions.
To retract the flash, push it back down.
•
The focus-confirmation beeper can be silenced with the menu’s [Beep]
setting (˙).
•
While focusing with <AF >, do not touch the focusing ring at the front of
the lens.
•
If you want to zoom, do it before focusing. Turning the zoom ring after
achieving focus may throw off the focus.
•
When the CF card becomes full, the CF Full warning “ ” will
appear on the LCD panel and shooting will be disabled. Replace the CF
card with one that is not full.
•
If something obstructed the built-in flash from popping up, < >
will blink on the LCD panel. Fix this by setting the power switch to off
and on.
•
Using a non-Canon EF lens with an EOS camera may not result in
proper camera or lens operation.