FRIGIDAIRE FARE4044MW - Manual (Page 10)

10
OPERATING INSTRUCTIONS
energy saver
The energy saver option reduces the drying
temperature a few degrees to save energy. In conjunction
with automatic moisture sensors, cycle times will increase
slightly, but overall energy usage will decrease.
wrinkle release
Select wrinkle release if the dried load might not
be removed promptly at the end of the cycle. The dry
load will continue tumbling without heat to help reduce
wrinkling. When chime is selected, a beep will be
heard periodically. The load may be removed any time
during wrinkle release.
shrink guard
Select shrink guard to lower the initial drying
temperature to protect fabrics from overdrying.
chime
A signal will sound at the end of the cycle (and
periodically during wrinkle release) if this option is
selected. The signal has an adjustable volume level or
can be turned off.
line dry
Select this option to simulate hanging your laundry in
a summer breeze combined with the wrinkle-releasing
benefi ts of tumble action. Since drying times are
calculated with the dryer’s automatic moisture sensors
and heat is radically reduced or eliminated, cycle time
will be lengthened. As a result, depending on moisture
content of load, overall energy consumption decreases.
delay start
Press delay start to select a drying time convenient to
your schedule or during off peak energy hours. The delay
time selected will be displayed and begin counting down
when you push in the cycle selector knob to start the unit.
Cycle Options
To select an option, press options until the indicator
for the desired option fl ashes, then press select. If an
option is not available for a cycle, the indicator will not
light. Follow the same steps to delete an option.
Occasionally, a setting and option in the same cycle will
confl ict with each other, like sanitize temp and damp
dry level. When this happens, the option selected fi rst will
cause the confl icting option to not be selectable.
Í NOTE
To change options once the cycle has begun, push in
the cycle selector knob to pause the cycle, make the
new selections and push in the selector knob again to
restart the dryer.
Í NOTE
While counting down during delay start, you
will notice your dryer periodically tumbling for a
few minutes without heat to redistribute the load,
maximizing load freshness.