Operating instructions, Important – FRIGIDAIRE FFFW5000QW User Manual

Page 12

Advertising
background image

12

OPERATING INSTRUCTIONS

Other Features

1

2

3

Snap

Hinge

IMPORTANT

Do not attempt to close door if vent latch arm is

disengaged and arm is in an outward position. Return

latch arm to lower position before closing and latching

the door.

NOTE

The vent latch may become dislodged from hinge point

if door closure is attempted while latch arm is not in

an acceptable closing position. The latch arm can be

snapped back in at the hinge location. Washer will still

operate without latch arm installed.

Delay Start

Press delay start to select a wash time convenient to

your schedule or during off peak energy hours. The delay

time selected will be displayed and begin counting down

when you select START.

Control Lock

To avoid having someone accidentally start the washer,

press options and select at the same time and hold

for 10 seconds until “

LOC

” is displayed alternately with

the estimated cycle time. To unlock the controls, press

Options and Select at the same time and hold 10 seconds

until “

LOC

” is no longer displayed.

Status Display/Status Lights

The estimated total cycle time will be displayed when

the cycle is selected. The time may increase if water

pressure is low, oversudsing occurs or the load becomes

unbalanced. The estimated remaining cycle time is

displayed during the cycle. The following indicators may

be lighted during the cycle:
• Door Lock

• Sensing

• Wash

• Touch Pause to Add a Garment

Vent Latch

Help prevent odor buildup and mildew between washes

by utilizing your washer’s vent latch feature. To apply the

vent latch, (1) open the door slightly, (2) lift the latch

arm and then (3) press the arm down onto the plastic

door strike, snapping it in place.
The vent latch can be released either of two ways - by

pulling door out and manually returning latch arm to

lower position or by pushing door shut and allowing latch

arm to continue its pivot upward.

cancel

spin

speed

START

pause

soil

level

options

select

auto

temp

delay

start

Press and hold both for ten seconds

to lock or unlock the controls.

Advertising
This manual is related to the following products: