Installation, Cut countertop opening, Install electrical outlet – FRIGIDAIRE FH30DD50MS User Manual

Page 9

Advertising
background image

9

1. Cut Countertop Opening

- Lay out and cut the cooktop cut-out far enough forward

so downdraft will fit behind it (refer to cooktop installation

instructions).
- Set cooktop in place and slide it as far forward as possible.

Center and square it with edges of countertop.

3. Prepare the Downdraft Blower

System Duct Connection

The downdraft is shipped with blower oriented for exhaust

discharge down. Follow directions below to change to left

or right exhaust discharge.
Remove the blower and slide plate from the chassis housing

by removing the two Phillips screws from the bottom slots

and detaching the slide plate from the top tabs.
Remove the four 1/4” nylon insert nuts from the blower

studs and detach the slide plate. Rotate the blower 90

degrees left or right as required for ducting and reattach

to the slide plate. Re-install the four 1/4” nylon insert nuts

on the blower studs.
Replace the blower and slide plate assembly by placing the

slide plate underneath the top tabs and re-installing the two

Hex Head screws in the bottom slots.

- Place the template against the back flange of the cooktop

and center it. Trace around template to mark the downdraft

opening.
- Remove cooktop from countertop.
- Cut downdraft opening. Be careful not to chop edges of

countertop. Mask the countertop to help prevent scratching

the surface.
- A ½” minimum clearance behind cutout must be maintained

behind the telescopic downdraft for proper installation.

INSTALLATION

NOTE

Cabinet constructions may vary. Be sure to take cabinet

frame members into account. They may have to be

removed or relocated. Do not compromise the structural

integrity of the cabinet in doing so.

A ½” minimum

clearance behind

cutout must be

maintained for

proper installation.

Template

2. Install Electrical Outlet

- Mount a standard wiring box, with

3-pronged grounded receptacle,

inside the cabinet. Make sure the

downdraft’s power cord can easily

reach it.
- Run appropriate power cable

into cabinet and connect it to

receptacle.

Rotate L

eft or R

ight

1/4” Nylon Insert Nuts

Slide Plate

Blower

Hex Head Screw

(1 Each Side)

Top Tab

Chassis Housing

Advertising
This manual is related to the following products: