Canon SELPHY ES2 - Manual (Page 74)

74 Using the Battery Pack (SELPHY ES2 only)
Charging the Battery Pack
Install the battery pack NB-ES1L and charge it.
• It takes approximately 4 hours to bring a depleted battery pack to a full charge state (based on
standard Canon testing criteria).
- We recommend recharging the battery pack in a temperature of 5 - 40 °C (41 - 104 °F).
- The charging time will vary depending on the ambient temperature and charge state.
• If Auto Power Down is set to [On], the printer will automatically turn off when powered by the
battery if it is not used for five minutes or more.
1
Install the battery pack in the printer.
• For details on how to install, refer to Installing
the Battery Pack (p. 73).
2
Connect the compact power adapter to
the printer.
• For more connection details, refer to Placing/
Connecting the Printer (p. 22).
• Charging starts.
3
Disconnect the compact power adapter
cord from the printer once charging is
complete.
Situate the printer with at least
15 cm (6 in.) of free space in
front and back and at least 10
cm (4 in.) of free space on the
sides.
To power outlet
15 cm
(6 in.)
10 cm
(4 in.)
15 cm
(6 in.)
2 • The power lamp lights orange
while charging and turns off
once the battery pack is fully
charged.
• If the printer's power turns on
while charging the battery pack,
charging will stop. If the power
is turned off again, charging will
resume.
• Turn the printer power off and
turn it on again if the battery
does not start charging.