Dell PowerEdge 2800 User Manual
Page 9
Installing the 1 x 2 SCSI Module
1-7
2
Connect the SCSI connector on the 1 x 2 backplane to the riser card or the optional RAID
controller card.
If your 1 x 2 module connects to the onboard riser card:
a
Connect the SCSI connector on the 1 x 2 backplane to SCSI channel A on the riser card.
See Figure 1-4.
b
Insert the SCSI cable harness into cable routing slot 1. See Figure 1-4.
If your 1 x 2 module connects to the optional RAID controller card:
a
Connect the SCSI connector on the 1 x 2 backplane to SCSI channel A (channel 0)
on the optional RAID controller card. See Figure 1-4.
b
Insert the SCSI cable into cable routing slot 2 and the cable routing slots located
at the bottom of cooling fan 8. See Figure 1-3.
3
Install the hard drives into the 1 x 2 module.
Figure 1-4.
1 x 2 Module and SCSI Backplane Connectors
peripheral bay
power connector
power
connector
6-pin
connector
SCSI
connector
1 x 2 module
SCSI backplane
F6590bk0.book Page 7 Tuesday, July 6, 2004 4:33 PM