Cisco 2955 - Manual (Page 2)

2
Catalyst 2955 Switch DIN Rail Clip Installation Notes
OL-5262-01
Overview
Overview
The rear panel of the Catalyst 2955 switch has a DIN rail mounting clip assembly, as shown in Figure 1 .
Figure 1 DIN Rail Clip Parallel Mounting Configuration
Mounting the Switch on a DIN Rail
You can mount the Catalyst 2955 switch on a DIN rail in a parallel or a face-down configuration.
The switch ships with the DIN rail clip assembly installed on the rear panel, for a parallel mounting
configuration. To mount the switch in a face-down configuration, unscrew the four DIN rail clip
mounting screws from the rear panel, and then reuse the screws to install the clip on the top of the switch,
as shown in
Figure 2 .
1 Catalyst 2955 switch rear panel 3 DIN rail clip mounting screws
2 DIN rail clip assembly
104560
3
2
1