Figure 1-4, Marking the vertical rails – Dell PowerEdge 2800 User Manual
Page 13
Advertising
Rack Installation Guide
1-11
2
Place a mark 88 mm (3.5 inches) above the original mark you made (or count up six holes in
a rack that meets EIA-310 standards) and mark the rack’s front vertical rails with a felt-tipped
pen or masking tape (if you counted holes, place a mark just above the top hole). This mark or
piece of tape indicates where the system’s upper edge will be located on the vertical rails
(see Figure 1-4).
Figure 1-4.
Marking the Vertical Rails
tape on vertical rail
Advertising