Removing the drive-bay shroud, Replacing the drive-bay shroud – Dell Alienware Aurora (Late 2009) User Manual
Page 19
019
019
/
CHAPTER 4: SHROUDS
2
1
1
tabs (2)
2
drive-bay shroud
Removing the Drive-Bay Shroud
Follow the instructions in “Before You Begin” on page
1.
6.
Remove the left side-panel (see “Removing the Left Side-Panel“ on page
2.
11).
Open the PCI shroud (see “Opening the PCI Shroud” on page
3.
Press the tabs and slide the drive-bay shroud towards the back of the
4.
chassis.
Disconnect the drive-bay shroud battery cable from the connector on the
5.
master I/O board.
Replacing the Drive-Bay Shroud
Follow the instructions in “Before You Begin” on page
1.
6.
Connect the drive-bay shroud battery cable to the connector on the master
2.
I/O board.
Align the drive-bay shroud with the slots on the chassis.
3.
Slide the drive-bay shroud toward the front of the chassis until it clicks into
4.
place.
Close the PCI shroud (see “Closing the PCI Shroud” on page
5.
18).
Replace the left side-panel (see “Replacing the Left Side-Panel“ on page
6.
11).
Connect your computer and devices to electrical outlets and then turn
7.
them on.