Dell 1100MP - Manual (Page 11)

Using Your Projector
11
Using Your Projector
Turning Your Projector On
NOTE:
Turn on the projector before you turn on the source.The Power button
light blinks green until pressed.
1 Remove the lens cap.
2 Connect the power cord and appropriate cables. For information about
connecting the projector, see "Connecting Your Projector" on page 7.
3 Press the Power button(see "About Your Projector" on page 6 to locate the Power
button). The Dell logo displays for 30 seconds.
4 Turn on your source (computer, DVD player, etc.). The projector automatically
detects your source.
NOTE:
Allow the projector some time to search for the source.
If the " Searching... " message appears on the screen, ensure that the
appropriate cable(s) are securely connected.
If you have multiple sources connected to the projector, press the Source button
on the remote control or control panel to select the desired source.
Turning Your Projector Off
NOTICE:
Do not unplug the projector before properly shutting down as
explained in the following procedure.
1 Press the Power button.
2 Press the Power button again. The cooling fans continues to operate for 90
seconds.
3 Disconnect the power cord from the electrical outlet and the projector.
NOTE:
If you press the Power button while the projector is running, the
following message appears:
"
Press Power button to Turn Off Projector.Projector
must cool down for 90 seconds before unplugging or
restarting. " The message disappears in 5 seconds or you can press any
button on the control panel.