Dell 1100MP - Manual (Page 26)

www
.dell.com | support.dell.com
26 Troubleshooting Your Projector
Changing the Lamp
Replace the lamp when the message " Lamp is approaching the
end of its useful life. Replacement suggested!
www.dell.com/lamps " appears on the screen. If this problem persists
after replacing the lamp, contact Dell.
CAUTION:
The lamp becomes very hot when in use. Do not attempt to replace
the lamp until the projector has been allowed to cool down for at least
30 minutes.
CAUTION:
Do not touch the bulb or the lamp glass at any time. The bulb may
explode due to improper handling, including the touching of the bulb or the
lamp glass.
1 Turn off the projector and disconnect the power cord.
2 Let the projector cool for at least 30 minutes.
3 Loosen the 2 screws that secure the lamp cover, and remove the cover.
4 Loosen the 2 screws that secure the lamp.
5 Pull up the lamp by its metal handle.
6 Reverse steps 1 through 5 to install the new
lamp.
7 Reset the lamp by usage time selecting the left
Lamp Reset icon in the OSD Management tab.
NOTE:
Dell may require that lamps replaced
under warranty be returned to Dell.
Otherwise, contact your local waste disposal
agency for the address of the nearest
deposit site.
NOTE:
The lamp contains mercury. Disposal
of this material may be regulated due to
environmental considerations. For disposal
or recycling information, please contact your
local authorities or the Electronic Industries
Alliance: www.eiae.org.