Dell PowerEdge 6950 - Manual (Page 15)

Dell™ Rack Installation Guide
13
Installing the RapidRails Slide Assemblies
1 At the front of the rack cabinet, position one of the RapidRails slide
assemblies so that its mounting-bracket flange fits in the appropriate
location on the rack (see Figure 1-5).
The top mounting hook on the rail assembly’s front-mounting bracket
flange should enter the top hole between the marks on the vertical rails.
2 Push the slide assembly forward until the top mounting hook enters the
square hole just below the upper marks or tape you placed on the vertical
rail. Next, push down on the mounting-bracket flange until the mounting
hooks seat in the square holes and the push button pops out and clicks
(see Figure 1-5).
3 At the back of the cabinet, pull back on the mounting-bracket flange
until the mounting hooks are in the appropriate holes, and then push
down on the flange until the mounting hooks seat in the square holes
and the push button pops out and clicks.
4 Repeat steps 1 through 3 for the slide assembly on the other side
of the rack.
NOTE:
Ensure that the rails are mounted at the same vertical position
on both sides of the rack.