Dell PowerVault 735N (Rackmount NAS Appliance) - Manual (Page 6)

1-4 Installing VersaRails

 
 



 
   



   
NOTE: Ensure that you use the mounting holes, as shown in Figure 1-1 and
Figure 1-2, to secure the front of the VersaRails to the rack. The second and fourth
mounting holes from the bottom of the VersaRail are used to secure a 2U system to
the rack. The first and second mounting holes from the bottom of the VersaRail are
used to secure 4U and 7U systems to the rack.
4. Slide the back VersaRail’s mounting flange backward until the back mounting
flange fits snugly against the inner side of the back vertical rail.
5. With the VersaRail level, secure the back of the VersaRail to the rack using two
Phillips-head screws (see Figure 1-3).
6. Repeat steps 2 through 5 to install the second VersaRail.
0.125-inch
rail spacing
bottom of
VersaRail
first mounting
hole
right-front rail