Removing the hard-drive fan assembly – Dell Alienware Aurora R2 (Early 2010) User Manual
Page 42
Advertising
042
042
/
CHAPTER 8: FANS
1
2
1 hard-drive fan assembly cable
2 hard-drive fan assembly
Removing the Hard-Drive Fan Assembly
Follow the instructions in “Before You Begin” on page
1.
6.
Remove the left side-panel (see “Removing the Left Side-Panel“ on page
2.
11).
Open the PCI shroud (see “Opening the PCI Shroud” on page
3.
Remove the drive-bay shroud (see “Removing the Drive-Bay Shroud” on
4.
page 19).
Disconnect the hard-drive fan assembly cable from the connector on the
5.
master I/O board. Make note of the cable routing before disconnecting the
cable.
Lift the hard-drive fan assembly out of the chassis.
6.
Advertising