Dell Alienware Aurora R2 (Early 2010) - Manual (Page 43)

043
043
/
CHAPTER 8: FANS
Replacing the Hard-Drive Fan Assembly
Follow the instructions in “Before You Begin” on page 1. 6.
Push the hard-drive fan assembly into the hard-drive fan assembly bay. 2.
Route the cable through the slot in the hard-drive bay. 3.
Connect the hard-drive fan assembly cable to the connector on the master 4.
I/O board.
Replace the drive-bay shroud (see “Replacing the Drive-Bay Shroud” on
5.
page 19).
Close the PCI shroud (see “Closing the PCI Shroud” on page
6. 18).
Replace the left side-panel (see “Replacing the Left Side-Panel“ on page 7. 11).
Connect your computer and devices to electrical outlets and then turn 8.
them on.