Crestron electronic Green Light GLPS-HSW-FT - Manual (Page 44)

Crestron Commercial Lighting Design Guide
40
Room Soluti
ons
GLPAC-DIMFLV
The GLPAC family is a Crestron Green Light integrated lighting system, designed for use as a standalone lighting controller in
classrooms, conference rooms, and even across multiple offices. While able to control 4 or 8 channels of dimmable fluorescent loads,
each GLPAC also provides a link to a centralized Crestron lighting control system for control and monitoring. Add optional real-time
power monitoring and Crestron RoomView Enterprise management software to help track and minimize energy usage facility-wide. The
GLPAC has a LAN port for fast communication with other control processors or directly with RoomView. Its two Cresnet ports allow one
remote connection to a centralized processor or another GLPAC and a local connection for keypads and touchpanels.
> Four or eight channels of 0-10 Volt fluorescent dimming
> Supports 100 to 277 Volt applications
> 16 Amp load rating per channel
> Built-in control system with Cresnet port
> Preloaded program for quick setup
> Optional real time power monitoring
> Control up to four rooms with a single GLPAC-DIMFLV
> Positive air gap at each output
> Phase-independent channels
> Local controls for setup, testing and verification
> Local and remote override capability
> Non-volatile power failure memory
>
Four low-voltage 1A rated relays (-PM models only)
> Eight digital input ports
> Four occupancy sensor inputs and four photocell inputs
> Local Cresnet supports keypads, touchpanels, etc.
Load Ratings
Dimmer Channels GLPAC-DIMFLV4(-PM): 4
GLPAC-DIMFLV8(-PM): 8
Per Channel 16 Amps at 100-277 Volts AC, 50/60 Hz
Dim Load Types 0-10 Volt fluorescent ballast (4-wire); 0-10V LED drivers; 60 mA max current sink
Switch Load Types Fluorescent Ballast, Incandescent, Magnetic Low-Voltage, Electronic Low-Voltage, Neon/Cold
Cathode, High-Intensity Discharge, Motor
Relay Lifetime Resistive rating: 100,000 on/off operations, 50A @ 277 VAC
General rating: 50,000 on/off operations, 16A @ 120/277 VAC
Power Requirements
Primary 100-277 Volts AC, 50/60Hz, supplied via channel 1 (L1, N1)
Available Cresnet Power 10 watts at 24 Volts DC, shared with occupancy and photocell sensor ports
Environmental
Temperature 32° to 104°F (0° to 40°C)
Humidity 10% to 90% RH (non-condensing)
Electrical Regulatory Certifications
UL508, Section 41 (Endurance Test) and Section 61C (Electronic Ballasts)
IEC60669-2-1, Section 19.102 (Contact mechanisms incorporated in electronic switches, intended for fluorescent lamp circuits or
other capacitive loads)
CE