Dell PowerEdge 2970 User Manual
Page 17
Advertising
Information Update
17
Figure 1-3.
SAS/SATA Backplane Board Removal
4 If present, disconnect the optical drive power cable from the SAS/SATA
backplane board. See Figure 1-4 for the location of the optical drive power
connector.
5 Disconnect the SAS cable(s) from the backplane connectors.
See Figure 1-4 for the location of the SAS cable connectors.
6 If an optical drive is installed, disconnect the data cable from the back
of the optical drive.
7 If present, remove the storage controller daughter card. See "Removing
a SAS Controller Daughter Card" in your Hardware Owner’s Manual.
1
drive carrier
2
SAS backplane board
3
SAS-backplane board release pin
3
1
2
Advertising