Compaq MP1800 - Manual (Page 18)

1-12 Getting Started
Part Number: 191443-001 - Writer: JGilbert - Saved by: J Abercrombie
Pages: 18 Words: 2604 Saved date: 05/17/004:43 PM File Name: Ch01
4. Turn on the video source (computer, PC Companion,
videocassette recorder, etc.) and launch the software application
being used to display images on the projection screen.
If applicable, press the Function key on the computer
designated for external display.
✎ If there is a long delay between the time the startup
screen displays and the time the presentation software
is launched, the lamp may shut off and the projector
will automatically go into standby mode. If this
happens, press the Standby button to power on the
lamp.
✎ When the startup screen disappears, the video from
the attached computer displays. If there is no
incoming video, the “Check Video Cable” message
will display on the projection screen.
Powering Off the Projector
1. Press the Standby button to turn off the projector lamp.
The message “Going to Standby” displays and the LED on the
Standby button blinks amber.
IMPORTANT: Allow the projector to cool down for about
five to ten minutes before turning it off.
2. Turn off the main power switch on the back of the projector.
3. Disconnect the power cord from the electrical outlet and the
projector.
CAUTION: After the projector is turned off, wait at
least one minute before turning the projector back on.
Failure to follow this caution can result in damage to
the projector.