Compaq MP1800 - Manual (Page 32)

2-8 Using the Projector
Part Number: 191443-001 - Writer: JGilbert - Saved by: J Abercrombie
Pages: 9 Words: 1439 Saved date: 05/17/004:43 PM File Name: Ch02
Special On-Screen Messages
Special on-screen messages will appear on the projection display to
identify the following conditions:
■ Check Video Cable: Indicates the video cable may not be
plugged into the projector or the selected video input is not
accurate.
■ Input Signal Out of Range— Indicates the projector is unable
to access the appropriate input signal.
■ 2 Inputs Active - Remove One— The projector has two data
inputs: one is an analog D-Sub input and the other is a digital
DFP input. This message indicates that both inputs are active
simultaneously and the user should detach one of them.
NOTE: This message appears only when the Multimedia
Adapter is not attached to the projector.
■ Going to Standby— Indicates the projector is entering a sleep
mode or is powering off the lamp.
■ Lamp May Fail Soon, Replacement Suggested— Indicates the
lamp is approaching failure. The message will remain on the
screen for five seconds or until the on-screen menu Select
button is pressed.