Casio EXILIM EX-ZR20 User Manual
Page 185
185
Appendix
A recorded image
was not saved.
1)Camera power may have been turned off before the save
operation was complete, which will result in the image not
being saved. If the battery indicator shows
, charge the
battery as soon as possible (page 21).
2)You may have removed the memory card from the camera
before the save operation was complete, which will result in
the image not being saved. Do not remove the memory card
before the save operation is complete.
Though available
lighting is bright,
the faces of people
in the image are
dark.
Not enough light is reaching the subjects. Change the flash
mode setting to < (Flash On) for daylight synchro flash (page
41), or adjust EV shift to the + side (page 50).
Night shots come
out bad.
Use the following BEST SHOT scenes (page 70) when shooting
at night.
• High Speed Night Scene (for shooting night scenery only)
• High Speed Night Scene and Portrait (for shooting people
against night scenery)
Subjects are too
dark when shooting
images in a
seashore or ski
area.
Sunlight reflected by water, sand, or snow, can cause
underexposure of images. Change the flash mode setting to
<
(Flash On) for daylight synchro flash (page 41), or adjust EV
shift to the + side (page 50).
Digital zoom will
not go up to the
maximum value.
1)The digital zoom setting may be turned off. Turn on digital
zoom (page 96).
2)Zoom will not go up to the maximum value if the “Zoom (SR)”
setting is “Single”. Change the setting to “Off” (page 55).
3)Zoom will not go up to the maximum value if the snapshot
size setting is “VGA”. Change to a different setting (page 38).
The image is out of
focus during movie
recording.
1)Focusing may not be possible because the subject is outside
the focus range. Shoot within the allowable range.
2)The lens may be dirty. Clean the lens (page 172).
3)During High Speed Movie recording, focus is fixed at the
position where it was when recording started. To focus an
image, half-press the shutter button for Auto Focus or focus
manually before you press [0] (Movie) to start recording.
Movie recording
suddenly stops.
The camera’s protection function may have activated because
camera temperature is too high. Wait until the camera
temperature drops to normal levels.
Problem
Possible Cause and Recommended Action