Sharp R-770B - Manual (Page 63)

E – 23
Menu Variation
eg
★
Congee with Pallock Fish and Peanuts
Ingredients:
100g Pallock fish (fried; chopped)
(3-5 persons) 50g Peanuts
1 slice salted turnip (chopped)
3 spring onions (chopped)
NOTE The ingredients can be added just after finish, with salted turnip and spring
onions as garnish and sprinkles on top.
★
Congee with salted pork and preserved duck eggs
Ingredients:
approx. 230g ( 1 /
2
lb) lean pork (chopped)
(3-5 persons) 2 preserved duck eggs (diced)
NOTE The ingredients can be added 10 min. before finish.
Serving (s) Rice Water
1 serve (1-2 persons) 150g 250ml
2 serves (3-5 persons) 300g 480ml
Serving (s) Rice Water
1 serve (1-2 persons) 50g 750ml
2 serves (3-5 persons) 80g 1400ml
Serving (s) Rice Water
1 serve (1-2 persons) 100g 700ml
2 serves (3-5 persons) 140g 1400ml
NOTE 1. Water temperature should be about 20
°
C at initial cooking.
2. The above serving should be entered in times of PCS as shown on the display.
R-2
Rice Cook Menu Guide
R-1
Menu Procedure
Menu
No.
Quantity
Rice
•
Wash rice until water runs clear.
•
Place rice and water into a deep cas-
serole (about 2 ) and soak for 30
mins.
•
Stir and cook with cover.
•
After cooking, stir lightly and stand
coverd for 5 mins.
•
Wash rice until water runs clear.
•
Place rice and water into a deep cas-
serole (about 2 ) and soak for 30
mins.
•
Stir and cook uncovered.
•
After cooking, stir and stand.
•
Wash rice until water runs clear.
•
Place rice and water into a deep cas-
serole (2
for 1 serve, 3 for 2 serves)
and soak for 15 mins.
•
Stir and cook uncovered.
• After cooking, stir and stand.
Congee
• You can select desired doneness by using
LESS/MORE setting. (See page E-34.)
Menu Variation
You can enjoy the variation by putting some ingredients into Porridge just after finish or 10 mins
before finish.
eg
★
Chicken porridge: 200g Chicken (cut small pieces, precooked)
(3-5 persons)
spring onion, cut 3cm long
★
Fish porridge : 250g fish (precooked)
(3-5 persons)
2 slices ginger (cut into stripes)
Porridge
•
You can select desired doneness by using
LESS/MORE setting. (See page E-34.)
•
You can select desired doneness by using
LESS/MORE setting. (See page E-34.)
R-3