Cisco Linksys SPA9000 - Manual (Page 197)

6-49
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 6 SPA9000 Field Reference
Line 1/2/3/4 Tab
SIP Debug Option SIP messages are received at or sent from the proxy listen port. This feature controls
which SIP messages to log. Choices are as follows:
• none—No logging.
• 1-line—Logs the start-line only for all messages.
• 1-line excl. OPT—Logs the start-line only for all messages except OPTIONS
requests/responses.
• 1-line excl. NTFY—Logs the start-line only for all messages except NOTIFY
requests/responses.
• 1-line excl. REG—Logs the start-line only for all messages except REGISTER
requests/responses.
• 1-line excl. OPT|NTFY|REG—Logs the start-line only for all messages except
OPTIONS, NOTIFY, and REGISTER
requests/responses.
• full—Logs all SIP messages in full text.
• full excl. OPT—Logs all SIP messages in full text except OPTIONS
requests/responses.
• full excl. NTFY—Logs all SIP messages in full text except NOTIFY
requests/responses.
• full excl. REG—Logs all SIP messages in full text except REGISTER
requests/responses.
• full excl. OPT|NTFY|REG—Logs all SIP messages in full text except for OPTIONS,
NOTIFY, and REGISTER requests/responses.
The default is none.
RTP Log Intvl The interval for the RTP log.
Restrict Source IP If Lines 1 and 2 use the same SIP Port value and the Restrict Source IP feature is enabled,
the proxy IP address for Lines 1 and 2 is treated as an acceptable IP address for both lines.
To enable the Restrict Source IP feature, select yes. Otherwise, select no.
If configured,
the PAP2T will drop all packets sent to its SIP Ports originated from an
untrusted IP address. A source IP address is untrusted if it does not match any
of the IP addresses resolved from the configured <Proxy> (or <Outbound
Proxy> if <Use Outbound Proxy> is
yes ).
The default is no.
Referor Bye Delay Controls when the SPA9000 sends BYE to terminate stale call legs upon completion of
call transfers. Multiple delay settings (Referor, Refer Target, Referee, and Refer-To
Target) are configured on this screen. For the Referor Bye Delay, enter the appropriate
period of time in seconds.
The default is 4.
Refer Target Bye Delay For the Refer Target Bye Delay, enter the appropriate period of time in seconds.
The default is 0.
Referee Bye Delay For the Referee Bye Delay, enter the appropriate period of time in seconds.
The default is 0.