Entering a password through the ivr, Initial setup and configuration – Cisco Linksys SPA9000 User Manual
Page 42
2-12
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 2 Getting Started
Initial Setup and Configuration
Entering a Password through the IVR
To input the password using the phone keypad, the following translation conventions apply:
–
To input: A, B, C, a, b, c—press “2’
–
To input: D, E, F, d, e, f—press “3’
–
To input: G, H, I, g, h, i—press “4’
–
To input: J, K, L, j, k, l— press “5’
–
To input: M, N, O, m, n, o—press “6’
–
To input: P, Q, R, S, p, q, r, s—press “7’
–
To input: T, U, V, t, u, v—press “8’
–
To input: W, X, Y, Z, w, x, y, z—press “9’
–
To input all other characters in the Administrator account password, press “0’
Note
This translation convention only applies to the password input.
For example, to input password test#@1234 by phone keypad, you need to press the following
sequence of digits: 8378001234.
1.
After entering a value, press the # (pound) key to indicate end of input.
–
To save value, press 1.
–
To review the value, press 2.
–
To re-enter the value, press 3.
–
To cancel the value entry and return to the main configuration menu, press
*
’ (star).
Notes:
–
The final # key is not included in the password value.
–
Saved settings take effect when the telephone is hung-up, and if necessary, the SPA9000
automatically reboots.
2.
After one minute of inactivity, the unit times out. The user needs to re-enter the configuration menu
from the beginning by pressing * * * *.
Initial Setup and Configuration
This section describes how to complete the initial connection and configuration of the SPA9000 system.
It includes the following topics:
•
•
Using DHCP or Static IP Addressing, page 2-13
•
Using the Wizard for Initial Configuration, page 2-13
•