When working inside your computer, When using your computer (continued) – Dell OptiPlex GX270 User Manual

Page 16

Advertising
background image

S e t u p a n d Q u i c k Re f e r e n c e G u i d e

15

When Working Inside Your Computer

Before you open the computer cover, perform the following steps in the sequence indicated.

CAUTION: Do not attempt to service the computer yourself, except as explained in

your online Dell documentation or in instructions otherwise provided to you by Dell.
Always follow installation and service instructions closely.

NOTICE: To help avoid possible damage to the system board, wait 5 seconds after turning off the

computer before removing a component from the system board or disconnecting a device from the
computer.

1

Perform an orderly computer shutdown using the operating system menu.

2

Turn off your computer and any devices connected to the computer.

3

Ground yourself by touching

an unpainted metal surface on the chassis, such as the metal

around the card-slot openings at the back of the computer, before touching anything
inside your computer.

While you work, periodically touch an unpainted metal surface on the computer chassis
to dissipate any static electricity that might harm internal components.

4

Disconnect

your computer and devices, including the monitor, from their electrical

outlets. Also, disconnect any telephone or telecommunication lines from the computer.

Doing so reduces the potential for personal injury or shock.

In addition, take note of these safety guidelines when appropriate:

When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the
cable itself. Some cables have a connector with locking tabs; if you are disconnecting this
type of cable, press in on the locking tabs before disconnecting the cable. As you pull
connectors apart, keep them evenly aligned to avoid bending any connector pins. Also,
before you connect a cable, ensure that both connectors are correctly oriented and
aligned.

Handle components and cards with care. Do not touch the components or contacts on a
card. Hold a card by its edges or by its metal mounting bracket. Hold a component such
as a microprocessor chip by its edges, not by its pins.

CAUTION: There is a danger of a new battery exploding if it is incorrectly installed.

Replace the battery only with the same or equivalent type recommended by the
manufacturer. Do not dispose of the battery along with household waste. Contact
your local waste disposal agency for the address of the nearest battery deposit site.

When Using Your Computer (continued)

Advertising