HP 9200c - Manual (Page 17)

Understanding digital-sender status
The digital sender has two buttons and three lights to indicate and control the digital-sender
status. To interpret the control-panel lights, see the follow table. For information about
troubleshooting digital-sender problems, see
Problem solving .
Digital Sender status indications
Element Status indication
S
LEEP
button When in Sleep mode, the green LED on the button is lit. Push this
button to enter or end Sleep mode.
S TART button The Start LED is green when the device is ready to scan. It is amber
if an error exists.
Ready LED The Ready LED is on when the device is online and able to send
data, or flashing when attempting to pause a job.
Data LED The Data LED is on if the job has been paused. It flashes when the
device is transmitting data.
Attention LED If the red Attention LED is lit or flashing, the device has encountered
an error.
Sleep mode
After 60 minutes of inactivity, the device automatically enters Sleep mode. In Sleep mode,
many of the digital sender's processes are shut down to conserve energy. The user can
press any button on the control panel to bring the device out of Sleep mode. The device
takes approximately 30 seconds to warm up and return to Ready mode. The settings for
Sleep mode can be changed by using the Configure Device menu on the control panel.
See the HP 9200C Digital Sender Support Guide for instructions about using this menu.
ENWW Control-panel features 11