Dell 926 All In One Inkjet Printer - Manual (Page 89)

Error
code: Error name: What it indicates: Solution:
Error
0000 NVRAM R/W Error detected in reading from
or writing to the NVRAM Press the Power button to reset
the printer.
Error
0001 Memory failure The printer is unable to initialize
memory. Press the Power button to reset
the printer.
Error
0002 Hardware failure A general hardware failure has
occurred, and the printer is
unable to detect what part of the
hardware system failed. Press the Power button to reset
the printer.
Error
0003 ROM checksum error A checksum error on the Read-
only memory has occurred. Press the Power button to reset
the printer.
Error
1003 Paper Calibrate Fail The printer failed to initialize or
calibrate the paper feed system. Disconnect the printer power cable,
check for paper jams, and then
reconnect the power cable.
Error
0200 Flash Programming - out
of memory The printer is unable to program
flash memory. Press the Power button to reset
the printer.
Error
1201 Print Incomplete (Bad
data to print head or
more data expected for
swath) The printer carrier stopped
before a print job was
completed. Press the Power button to reset
the printer.
Error
1202 Data Error Incorrect data has been sent
from the computer to the
printer. Press the Power button to reset
the printer.
Error
1203 Print Head Short A short circuit in the print head
has occurred. Disconnect and then reconnect the
printer power cable. Reinstall the
ink cartridges. For more
information, see
Replacing Ink
Cartridges .
Error
1205 Mono TSR Error The printer cannot determine
the temperature of the print
head due to a problem in the
mono TSR circuit. Reinstall the black ink cartridge. For
more information, see
Replacing Ink
Cartridges .
Error
1206 Color TSR Error The printer cannot determine
the temperature of the print
head due to a problem in the
color TSR circuit. Reinstall the color ink cartridge. For
more information, see
Replacing Ink
Cartridges .
Error
1207 Paper system Error The paper system control failed. Press the Power button to reset
the printer.
Error
2200 Scan Carrier Stall The scan carrier stalled during a
scan job. Turn off the printer, wait a few
seconds, and then turn on the
printer.
NOTE: Contact Customer Support at www.support.dell.com if the errors are not resolved.