Dell Precision T1700 (Mid 2013) - Manual (Page 18)

Removing the Intrusion Switch
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the cover.
3. Press the clip inwards to release and gently pull the intrusion cable from system board.
4. Slide the intrusion switch toward the front of the chassis and remove it from the computer.
Installing the Intrusion Switch
1. Insert the intrusion-switch into the chassis rear and slide it outward to secure it.
2. Connect the intrusion-switch cable to the system board.
3. Install the:
a) heat sink assembly
b) cover
4. Follow the procedures in After Working Inside Your Computer .
Memory Module Guidelines
To ensure optimal performance of your computer, observe the following general guidelines when configuring your
system memory:
• Memory modules of different sizes can be mixed (for example, 2 GB and 4 GB). But, all populated channels must
have identical configurations.
• Memory modules must be installed beginning with the first socket.
NOTE: The memory sockets in your computer may be labeled differently depending on the hardware
configuration. For example, A1, A2 or 1,2,3.
• If the quad-rank memory modules are mixed with single or dual-rank modules, the quad-rank modules must be
installed in the sockets with the white release levers.
18