Dell Dimension 5100C - Manual (Page 83)

Removing and Installing Parts
83
7 Replace the CD/DVD drive (see page 77).
8 Replace the computer cover (see page 91).
NOTICE:
To connect a network cable, first plug the cable in to the network device and then plug it in to
the computer.
9 Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
10 Enter system setup (see page 97) and select the appropriate Drive option.
11 Verify that your computer works correctly by running the Dell Diagnostics (see page 43).
Floppy Drive (Optional)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet
before removing the cover.
Removing a Floppy Drive
1 Follow the procedures in "Before You Begin" on page 53.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
3 Remove the computer cover (see page 59).
4 Remove the CD/DVD drive (see page 76).
5 Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
Then, lift up to remove the drive from the computer.