Dell UPS 1920T - Manual (Page 49)

49 Additional UPS Features |
Network Transient Protector
The network transient protector, shown in Figure 23, is located on the rear panel and has jacks labeled
IN and OUT. This feature accommodates a single RJ‐45 (10BaseT) network connector.
NOTE: DO NOT connect any telephone or fax/modem equipment (RJ-11) to the UPS.
1 Connect the input connector of the equipment you are protecting to the jack labeled IN.
2 Connect the network cable to the jack labeled OUT.
OUT IN
OUT
IN
500–1000W
1920/1500W
Figure 23. Network Transient Protector
Dell UPS Management Software
Each Dell Tower UPS ships with Dell UPS Management Software.
Dell UPS Management Software provides up-to-date graphics of UPS power and system data and power
flow. It also gives you a complete record of critical power events, and it notifies you of important UPS or
power information. If there is a power outage and the Dell Tower UPS battery power becomes low, the
software can automatically shut down your computer system to protect your data before the UPS
shutdown occurs.
For details on disabling control commands from the software, see the user setting for Control
Commands from Serial Port setting on page 37.