Dell Inspiron 2000 User Manual
Page 32
To remove the keyboard assembly, perform the following steps.
NOTICE: To avoid damaging the system board, you must
before you service the computer.
NOTICE: Make sure that the work surface is clean to prevent scratching the computer cover.
1. Remove the
.
2. Remove the four M2 x 4-mm screws located across the top of the keyboard assembly (see Figure 11).
3. Release the keyboard assembly from the palmrest assembly by lifting the top edge of the keyboard assembly up and sliding it toward the
back of the computer.
4. Rotate the keyboard up so it is perpendicular to the computer.
5. Carefully disconnect the keyboard cable from the connector on the system board.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and
handling the keyboard.
6. Remove the keyboard assembly.
To replace the keyboard assembly, perform the following steps.
NOTICE: Position the keyboard cable so it is not twisted when it is connected to the system board.
1. Connect the keyboard cable to the connector on the system board.
2. Fit the keyboard into place by sliding the five tabs on the bottom of the keyboard into the palmrest assembly.
It is important that the two tabs on the bottom right edge of the keyboard assembly fit correctly into the slotted holes in the palmrest assembly.
To help align the tabs with the slotted holes, you can temporarily insert the hard-disk drive into the hard-disk drive bay before you place the
keyboard assembly in the palmrest assembly. By resting the keyboard assembly on the hard-disk drive, the tabs will be at the correct height
to enter the slotted holes. When the keyboard assembly is seated in the palmrest assembly, remove the hard-disk drive and look through the
hard-disk drive bay to make sure the tabs are seated in the slot holes.
3. Ensure that the top screw-hole tabs rest correctly in the screw slots on the palmrest assembly.
4. Verify that the keyboard is correctly installed.
The keys should be flush with the left and right surfaces of the palmrest.
5. Reinstall the four M2 x 4-mm screws that secure the top of the keyboard assembly to the bottom assembly.
1 M2 x 4-mm screws (4)
2 Keyboard cable
3 Keyboard assembly
NOTE: Five metal tabs retain the bottom of the keyboard in the palmrest assembly.
NOTE: Five metal tabs retain the bottom of the keyboard in the palmrest assembly.