Dell OptiPlex Gxi - Manual (Page 74)

6-8 Dell OptiPlex GXi Mini Tower Systems Reference and Installation Guide
To remove the chip, pull the microprocessor-socket
release lever straight out until the chip is released
(see Figure 6-10). Then remove the chip from the
socket. Leave the release lever extended so that the
socket is ready for the new microprocessor.
Figure 6-10. Removing the Microprocessor
6. Unpack the new microprocessor.
If any of the pins on the chip appear to be bent, see
the chapter titled “Getting Help” in your Diagnostics
and Troubleshooting Guide for instructions on
obtaining technical assistance.
7. Align the pin-1 corner of the microprocessor chip
(see Figure 6-11) with the pin-1 corner of the
microprocessor socket (see Figure 6-12).
NOTE: Identifying the pin-1 corners is critical to
positioning the chip correctly.
Identify the pin-1 corner of the microprocessor by
turning the chip over and locating the tiny gold fin-
ger that extends from one corner of the large central
rectangular area. The gold finger points toward
pin 1, which is also uniquely identified by a square
pad.
Figure 6-11. Pin-1 Identification
The pin-1 corner of the socket is the bottom-right
corner of the socket as you face the side of the com-
puter (see Figure 6-1).
8. Install the microprocessor chip in the socket (see
Figure 6-12).
If the release lever on the microprocessor socket is
not all the way out, move it to that position now.
With the pin-1 corners of the chip and socket
aligned, align the pins on the chip with the holes in
the socket. Set the chip lightly in the socket and
make sure all pins are headed into the correct holes.
Because your system uses a ZIF microprocessor
socket, there is no need to use force (which could
bend the pins if the chip is misaligned). When the
chip is positioned correctly, it should seat itself in the
socket with minimal pressure.
CAUTION: Be careful not to bend any of the
pins when unpacking the microprocessor.
Bending the pins can permanently damage the
microprocessor.
microprocessor chip
microprocessor
socket
release lever
CAUTION: Positioning the microprocessor
chip incorrectly in the socket can permanently
damage the chip and the computer when you
turn on the system.
CAUTION: When placing the microprocessor
chip in the socket, be sure that all of the pins go
into the corresponding holes on all sides of the
socket. Be careful not to bend the pins.
pin-1 corner (gold finger
and square pad)