Dell PowerVault 160T LTO2 (Tape Library) - Manual (Page 86)

Specifications: Dell PowerVault 160T Tape Library User's Guide
file:///C|/Users/greshma_dhanarajan/Desktop/ug/specs.htm[5/16/2013 10:08:25 AM]
Back to Contents Page
Specifications: Dell™ PowerVault™ 160T Tape Library
User's Guide
Performance Specifications
Environmental Specifications
Electrical Specifications
Physical Specifications
Barcode Requirements
This section provides performance, environmental, electrical, and physical specifications for modules in the Dell PowerVault
160T Tape Library.
Performance Specifications
Library performance is 180 cartridge exchanges per hour (EPH) for a four module system with a maximum EPH of 265.
Environmental Specifications
Table 1 lists the key environmental information for the Dell PowerVault 160T Tape Library.
Table 1. Environmental Specifications
Temperature Humidity Altitude BTU/Heat Dissipation
Minimum
1
Maximum
2
59°F - 89.6°F (15°C - 32°C) 15 - 75% 10000 ft .375 kwh
1280 BTU
4.3 kwh
14651 BTU
1
Configuration includes a control module with one drive.
2
Configuration includes a control module and three expansion modules with a total of 48 drives.
Electrical Specifications
Each system is configured with a redundant power configuration. Both control and expansion modules require two independent
AC power sources.
NOTICE: You must install your library with two different power sources to have redundant power. You will NOT have
redundant power if you use only one AC power source. If a power failure occurs, your library will fail.
The power cable length for each of these inputs is 14 feet (4.26 m). Refer to Table 2 .
Table 2. Electrical Specifications
Module Voltage (Single Phase,
50 - 60 Hz)
Max AMP
Rating
United States Power
Connector (220V)
United States Power
Connector (110V)
Control 100 - 240 30 L6 - 30 L5 - 30
Expansion 100 - 240 30 L6 - 30 L5 - 30