Setting up the monitor, Attaching the stand, Connecting your monitor – Dell E2210 Monitor User Manual
Page 27
Back to Contents Page
Setting Up the Monitor
Dell™
E1910/E2210 Flat Panel Monitor User's Guide
Attaching the Soundbar (optional)
Attaching the Stand
To attach the monitor stand:
1. Remove the cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3. Press the stand till it snaps into its place.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
Connect the blue (VGA) cable from your monitor to your computer.
2.
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use both cables on the same computer.
Use both the cables only when they are connected to two different computers with
appropriate video systems.
NOTE:
The stand is detached when the monitor is shipped from the factory.
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.
NOTE:
If your computer supports a white DVI connector, connect the white DVI cable (that ships with your monitor) to
the monitor and the DVI connector on your computer.
NOTE:
Do not connect both the blue VGA and the white DVI cables to the computer as all monitors ship with the VGA cable
attached to the monitor.