Dell PowerEdge M605 - Manual (Page 42)

40
Configuration Guide
4 Configure the switch for integration into your network.
– Select DHCP Mode Enabled if your network uses a DHCP server to
assign IP addresses.
– If your network uses static IP addressing, enter an IP address, subnet
mask and gateway.
5 When you have finished, click Apply.
6 Click the Deploy sub-tab.
After all I/O modules have been configured and connected, the enclosure’s
blades can be inserted and booted with full network communication.
Cisco SFS M7000e Infiniband Switch Module
The Cisco SFS 7000e Infiniband switch module includes 24 4x DDR
Infiniband ports. Eight ports are external uplink ports, and 16 internal ports
provide connectivity to the blades in the enclosure. This switch module is
hot-pluggable and may be installed in Fabric B or Fabric C. See Figure 3-2.
R433Cbk0.book Page 40 Wednesday, July 30, 2008 6:05 PM