Camera, Removing the camera, Replacing the camera – Dell Inspiron 11z (1120, Mid 2010) User Manual
Page 12
Back to Contents Page
Camera
Dell™ Inspiron™ 1121 Service Manual
Removing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Follow the instructions from
step 4
to
step 6
in
Removing the Hard Drive
.
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Remove the display assembly (see
Removing the Display Assembly
).
7.
Remove the display bezel (see
Removing the Display Bezel
).
8.
Disconnect the camera cable from the connector on the camera module.
9.
Lift the camera module off the display back cover.
Replacing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Place the camera module on the display back cover using the alignment posts.
3.
Press down on the camera module to secure it to the display back cover.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
display back cover
2
camera module
3
camera cable connector