Dell POWEREDGE M1000E - Manual (Page 12)

Installation and Basic Operation Rev 1.0
12
2.4.3 Installation Safety Warnings
1. Installation Instructions
2. Over-temperature
3. During Lightning - Electrical Hazard
4. Copper Direct Attached SFP+ Cable Connecting/Disconnecting
5. Equipment Installation
6. Equipment Disposal
7. Local and National Electrical Codes
8. Hazardous Radiation Exposure
Read all installation instructions before connecting the equip-
ment to the power source.
This equipment should not be operated in an area with an ambi-
ent temperature exceeding the maximum recommended: 40°C
(104°F). An air flow of 9CFM at this maximum ambient temper-
ature is required.
During periods of lightning activity, do not work on the equip-
ment or connect or disconnect cables.
Copper Direct Attached SFP+ cables are heavy and not flexible,
as such they should be carefully attached to or detached from the
connectors. Refer to the cable manufacturer for special warnings
and instructions.
This equipment should be installed, replaced, or serviced only
by trained and qualified personnel.
Disposal of this equipment should be in accordance to all
national laws and regulations.
This equipment should be installed in compliance with local and
national electrical codes.
Caution – Use of controls or adjustment or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.